Support for BekTek® ENDEC DJ and ENDEC Pro software.
NEW! ENDEC PRO for Firmware version 6.1 or newer - Version 1-5
If you are a current user of ENDEC PRO, and you have a passkey installed on your system, you can download an update to older versions of ENDEC PRO. This will allow you to interface to the new ENDEC firmware (version 6.1).
You must have firmware version 6.1 or newer installed in your ENDEC. You must have an ENDEC PRO passkey.
This version of the ENDEC PRO software includes support for all of the new event codes and all of the new NWS marine codes. You do not need to manually update events or locations.
This version of ENDEC PRO setup includes the passkey drivers, you do not need to manually install them.
To install, unzip the update into an empty folder and run setup.exe from that folder. This version of ENDEC Pro supports ENDEC ROM version 5.125, and 6.x only. If you need to support both versions of the ENDEC, be sure to install this version in a different folder than the older version.
ENDEC DJ version 1.7
for Firmware version 6.1 or newer
If you are a current user of ENDEC DJ, and you have a passkey installed on your system, you can download an update to older versions of ENDEC DJ. This will allow you to interface to the new ENDEC firmware (version 6.1).
You must have firmware version 6.1 or newer installed in your ENDEC. You must have an ENDEC DJ passkey.
This version of the ENDEC DJ software includes support for all of the new event codes and all of the new NWS marine codes. You do not need to manually update events or locations.
This version of ENDEC DJ setup includes the passkey drivers, you do not need to manually install them.
To install, unzip the update into an empty folder and run setup.exe from that folder.
Event Codes
To upgrade ENDEC DJ version 1.3, and ENDEC PRO version 1.4 to handle the new event codes, download the zip file and follow the instructions in “Adding the New Event Codes3.doc”.
Download the events file (142kb).
Drivers
If you are reinstalling older version of ENDEC DJ or ENDEC PRO on Windows NT, 2000, or XP, you’ll need to install the following driver. This driver is included on later CDs. If you get a “passkey error 12” message, download this file, unzip, and run the .exe.
Download the driver file (3.4 MB)